Pressure booster - メーカー・企業と製品の一覧

Pressure boosterの製品一覧

1～2 件を表示／全 2 件

表示件数

Air Booster "Air Booster ABP2-HP1 Series"

Improving equipment longevity and productivity by considering compressed air! Generating high-pressure air at twice the primary pressure without a power supply.

The "Air Booster ABP2-HP1 Series" is an air pressure booster that can be compactly installed with an air tank. The cylinder part optimizes the design of the packing section, and the valve uses the long-lasting 4G series, achieving more than double the durability compared to conventional models. Installation can be adjusted to the layout using brackets. By utilizing existing compressed air equipment and boosting only the necessary areas, it contributes to energy savings in factories and reduces the total cost of the factory with long-lasting equipment. 【Features】 ■ Long lifespan ■ High reliability ■ Low noise ■ Flexible installation direction ■ Air tanks are available in two sizes: 5L and 10L *For more details, please refer to the PDF document or feel free to contact us.

企業：新光電機
価格：Other

Pneumatic Equipment

ブックマークに追加いたしました

ブックマーク一覧

ブックマークを削除いたしました

ブックマーク一覧

これ以上ブックマークできません

会員登録すると、ブックマークできる件数が増えて、ラベルをつけて整理することもできます

無料会員登録

Equipment and Unit Renovation (5) [Case Studies for Problem Solving]

Introduction of a case regarding the issues with TAIYO's direct pressure booster.

We received a report from Company F regarding the product "NBH Series" direct pressure booster (named New Malock) manufactured by TAIYO, which converts air pressure to hydraulic pressure up to a maximum of 17.5 MPa. During trial operation, there were metallic sounds, and the movement of the cylinder stopped partway (stuck). Upon checking the specifications, we noticed that the piping from the New Malock to the cylinder was long. After confirming this with the manufacturer, it was indicated that there might be a possibility of insufficient oil due to expansion loss in the piping hose, which was found to have an expansion loss of 10cc per meter. As a countermeasure to this issue, we implemented the following two points, which led to the resolution of the problem: (1) Shortened the piping as much as possible to increase the amount of oil. (2) Positioned the New Malock higher than the hydraulic cylinder and left it for a while to bleed the air. *For more details, please feel free to contact us.

企業：伸栄産業
価格：Other

others

ブックマークに追加いたしました

ブックマーク一覧

ブックマークを削除いたしました

ブックマーク一覧

これ以上ブックマークできません

会員登録すると、ブックマークできる件数が増えて、ラベルをつけて整理することもできます

無料会員登録

前へ 1 次へ